Zero point clamping system

Produce in series

Automate your workplace now with Siegmund's zero point clamping system and upgrade your welding table to increase the robot working load and ensure consistent quality.

Simple usage

The modules of the zero point clamping system are centered and fastened in the borehole of the welding table. The perforated plate is fastened using clamping bolts via the zero point clamping system.

Versions

The zero point clamping system is available in two versions. The mechanical variant is clamped or opened using an open-jaw wrench. With the pneumatic variant, the clamping bolt is loosened using compressed air. Without the supply of compressed air, the bolt is clamped.

Precise zeroing

The perforated plate can be aligned on the welding table with the zero point clamping system. The centering is done via the sockets.

Maximum efficiency with the new clamping system

In combination with the new clamping system, recurring welding devices can be manufactured with high accuracy and low down times. If a robot program already exists, you benefit from a minimal set-up time of your device.

Find out more about our new clamping system here

Specifications

• The basis of the system is the Siegmund welding table
• At least 4 clamping modules are required per perforated plate
• The perforated plate is clamped and centered using balls
• Re-adjustment of the clamped fixture is not necessary

Eelised

• Switch quickly between reused fixtures
• Minimization of non-productive welding times
• Suitable for use with and without welding robots
• High repeatable accuracy

Holding force and accuracy

• Maximum vertical holding force 2 kN per module
• Zeroing with high precision

Versions

• Actuation mechanical
• Actuation pneumatic