Replace devices in just a few simple steps
More information >High repeat accuracy with short set-up times
Fastening of the clamping modules in the boreholes of the welding table
More information >Mechanical or pneumatic actuation
More information >Simply remove and replace the complete perforated plate and fixture assembly and replace with another.
Automate your workplace now with Siegmund's zero point clamping system and upgrade your welding table to increase the robot working load and ensure consistent quality.
The modules of the zero point clamping system are centered and fastened in the borehole of the welding table. The perforated plate is fastened using clamping bolts via the zero point clamping system.
The zero point clamping system is available in two versions. The mechanical variant is clamped or opened using an open-jaw wrench. With the pneumatic variant, the clamping bolt is loosened using compressed air. Without the supply of compressed air, the bolt is clamped.
The perforated plate can be aligned on the welding table with the zero point clamping system. The centering is done via the sockets.
In combination with the new clamping system, recurring welding devices can be manufactured with high accuracy and low down times. If a robot program already exists, you benefit from a minimal set-up time of your device.
The ideal basis for your fixtures.
>> to the item list System 16